Votronic fully automatic battery charging converter VCC 1224-25 IUoU Input voltage 12 V / charging capacity 24 V / 25 A

Fully automatic battery charging converter for special vehicles, motorhomes, boats (charging converter, B2B battery to battery, battery charging while driving).

The charging converters (boosters) have been developed according to the latest specifications for charging supply batteries (on-board battery) with lead-acid, lead-gel or lead-AGM technology while driving.

In contrast to conventional cut-off relays, the charging voltage is increased depending on the charging specification in the case of long supply cables or insufficient cable cross-sections, thus compensating for the losses.

The charging converter thus provides the well-known high quality of battery charging of the VOTRONIC chargers even while driving. The intelligent microprocessor charging control with "IU1oU2" charging characteristics and dynamic charging time calculation automatically ensures fast and gentle full charging and subsequent 100% charge retention of the connected batteries from any state of charge and always enables simultaneous supply of 24 V consumers connected in parallel. Overcharging or excessive gassing of the batteries is prevented even during extremely long driving times.

The charging converters of the "IUoU" series are characterized by their compact design, low weight (high-frequency switch mode technology), powerfully dimensioned power components and thus full charging power even with long charging cables and strong voltage fluctuations at the starter battery (e.g. in vehicles according to Euro 6 standard).

Battery output and charging programs:

1. "Gel": Sealed, gas-tight gel batteries (dryfit, fixed electrolyte)
2. "AGM1": Sealed, gas-tight AGM batteries (Absorbent Glass Mat, lead-fleece technology)
   max. charging voltage 29.4 V
3. "AGM2": Sealed, gas-tight AGM batteries (Absorbent Glass Mat, lead-fleece technology)
   max. charging voltage 28.8 V
4. "Lead Acid": Closed and open acid/wet lead-acid batteries (factory setting).

Details

• Galvanic insulation
• Lead temperature compensation
• Automatic activation D+, ignition
• Connections for sensor line for input / output
• Connections for remote control, display
• Temperature sensor 825 included in scope of delivery
• Dimensions (L x W x H): 270 x 139 x 74 mm

Technical data Input IN Starter battery

• Nominal battery voltage: 12 V / 24 V (depending on version)
• Battery capacity min.: 80 Ah / 60 Ah (depending on version)
• Power consumption max.: 800 W

Technical data output OUT on-board battery

• Nominal battery voltage: 24 V
• Battery capacity recommended/up to: 50-170 / 220 Ah
• Charging current main charge, I-phase, 16 V to U1, 0-15 h: 25 A
• Charging/buffer/load current, regulated U1-U2 phase: 0 - 25 A

General technical data

• Charging voltage limit (load protection): 30,0 V
• Input for battery temperature sensor: yes
• Charging timer: 3-fold
• Reverse polarity/short circuit/back discharge/safety protection: yes
• Safety timer per charging phase I-/U1-/(U2-): yes
• Device installation position: any
• Temperature range: -20/+45 °C
• Protection class: IP2X
• Weight: 1700 g
• Dimensions, incl. mounting flange/feet: 270 x 139 x 74 mm
• Ambient conditions, humidity: max. 95 % RH, non-condensing

For further technical data, please refer to the operating instructions.

Scope of delivery

• 1 charging converter
• 1 temperature sensor 825
• 1 installation and operating instructions